Email Micon MouldContact Us Today: +86-576-84136087 / Huangyan, Taizhou, China(318020)


Bucket mould maker

Dec. 16, 2016

Plastic Bucket Mould, Pail mould
1. In order to improve the mould life and product quality, we increase the mould steel hardness through heat treatment. The steels we commonly use are H13(48-52HRC), 2316(45-50HRC) etc.To prevent mould eccentric, we use whole piece of steel to make the bucket mould. The cooling system is very important. We adopt single loop cooling way and setup even distribution water channels as much as possible.
bucket mould bucket mould bucket mould
To enhance the cooling effect, BeCu can be inserted on the core and cavity, see pictures as below:
bucket mould bucket mould
2. Our bucket moulds use air assistance,stripper plate and centre ejector for demolding (release in two steps). In order to increase cooling performance, there also have water channels in the centre.
bucket mould bucket mould bucket mould
3. All small sliders will be nitrided to increase the hardenss.
bucket mould bucket mould
4. It is important to keep maintenance for the bucket moulds. We should check and make sure the the water channels and air circuit unlocked. Add lubricant oil for the siliders, regularly clean the stripper plate and centre ejector.

Telephone +86 576 84136087 WhatsApp+86 153 06761345WeChat +86 153 06761345